Priming sugar and carbonation drops calculator

Choose how fizzy you want it, your bottle size and how warm the beer has been, and see how much sugar the batch needs and how much goes in each bottle, or how many carbonation drops to use.

The calculator

Usually the temperature it fermented at, not at bottling: cold crashing doesn’t put back the CO₂ it lost while warm.

Ours are 1.56g (140g for 90). Remembered for next time.

Your priming

Sugar for the batch
–g
Sugar per bottle
–g
Carbonation drops per bottle
–
Bottles, about
–

–gFor the batch–gPer bottle–Drops per bottleCheck your readingsAll results

How it works

Fizz is measured in volumes of CO₂: the litres of gas dissolved in each litre of beer. A British bitter sits around 1.5 to 2, a pale ale around 2.4, a lager about 2.6, and wheat beers and sours 3 or more.

Beer keeps some CO₂ from fermentation, more the cooler it has been, so the calculator uses the warmest temperature the beer reached after fermentation. The bottles make the rest from priming sugar: about 4g of table sugar per litre for each volume, 4.4g of brewing sugar (dextrose), or 5.3g of spraymalt.

Carbonation drops are just measured sugar. Ours weigh about 1.56g each (a 140g pack of 90), but weigh one of yours: brands differ.

From our brews

I Am Your Guava went into 330ml bottles with one drop each: about 2.0 volumes, which is why it came out a little flat for a pale ale. Two drops in a 500ml bottle gives about 2.4, which is what we’d use next time.

Zing had two drops in each 500ml bottle and fizzed like champagne. The sour yeast kept on eating, which is worth allowing for with sours and fruited beers.

Questions

How many carbonation drops per bottle?
For a typical pale ale, about two drops in a 500ml bottle and one and a half in a 330ml bottle. The calculator works it out for your bottle size, the fizz you want and the drops you have.
Can I over-carbonate and burst a bottle?
Yes, especially if the beer hadn’t finished fermenting. Only bottle once the gravity has held steady for two days, and stay under about 3 volumes in ordinary bottles.
Which temperature should I use?
The warmest the beer has been since fermentation finished, which is usually the temperature it fermented at, not the bottling temperature. Warm beer lets CO₂ escape, and chilling it afterwards doesn’t put it back, so if you fermented at 20°C and cold crashed to 2°C, enter 20°C.
What are volumes of CO₂?
How much gas is dissolved in the beer. At 2.4 volumes, a litre of beer holds 2.4 litres of CO₂: about right for a pale ale. A soft British bitter sits nearer 1.8, and a lively wheat beer or saison around 3.
Table sugar, brewing sugar or spraymalt: which should I use?
Any of them works. Brewing sugar (dextrose) is what most kits suggest, and you need about 10% more of it than table sugar for the same fizz. Light spraymalt needs more again, and adds a touch of malt flavour. Carbonation drops are just measured table sugar.
How long do bottles take to carbonate?
Usually two to three weeks somewhere around 18 to 21°C, then a few days in the fridge before you drink them. Stronger beers can take longer. Our Zing took three weeks to carbonate.
Should I prime the whole batch or each bottle?
Priming the batch gives every bottle the same fizz: dissolve the sugar in a little boiled water, pour it into the bottling bucket and syphon the beer on top. Priming each bottle, with carbonation drops or a measured spoonful, is simpler for small batches or when bottle sizes are mixed.

More tools

Fisher & Forbes Brewing Co, home